Spreader Arms - Nacra F20 Carbon Assembly & Rigging Manual

Step 2.
Place the diamond wire onto the diamond wire connector and attach it with a
clevis pin and ring. The ring should be on the outside. Don't forget to tape
the ring!
Step 3.
Put some wear tape under the diamond wire connector. Then bend the dia-
mond wire connector to the mast again.

1.6.3. Spreader arms

Step 1.
Take the forward and aft spreader bars and spreader bar adjuster screws
from the box. Grease the thread of the spreader bar adjuster screws with
marine grease. (e.g. Molykote Longterm W2)
Step 2.
Assemble the two spreader bars together by using the clevis pins from the
box.
Spreader arms
Step 1
Grease the threads
Step 2 and 3
Tape the ring
Step 2
19