Table of Contents
Advertisement
1.7. Rudders
Step 1.
Put your boat on high supports or the trailer, because we are going to put
the rudders on the boat. They should also be able to lock down. Then slide
your rudders on the rudder pins on the stern. The bent rudder arms should
be facing inboard.
Step 2.
Measure the rudder rake, taking the tape measure and measuring the distan-
ce from the black rudder casting and the center of the eye screw. The basic
setting is fully screwed in, so no visible thread. See the trim sheet for tips! To
adjust the rudder rake (the angle which the rudders make under the boat) it
is possible to screw the eye screw in or out when you take the rudders off
the pins.
Step 3.
If the rudder rake is right, then tighten the nut properly and slide the rudders
back onto the pins.
Step 4.
Install the hardware for the joystick in the middle of the crossbar. Make sure
the hardware is still able to turn around, so don't tighten it too firmly!
Step 2 and 3
Rudders
Step 1
Step 4
Don't overtighten
31
Advertisement
Table of Contents
