The Printer Setup Menu - Epson SureColor S30675 User Manual

Print Media List
Parameter
Print

The Printer Setup Menu

indicates default settings.
Item
Side Margin(Right)
Side Margin(Left)
Print Start Position
Media Size Check
Media End Check
Media Skew Check
2
Head Strike Warning
Explanation
Print the contents of media setting banks 1 to 30.
Parameter Explanation
3 to 25 mm (0.12 to Choose the width of the right margin when media is loaded in the
1.00 inch) printer. Margin widths vary with the model of printer used. See "Printable
area - S70675/S50675" on page 123 or "Printable Area - S30675" on page
126.
3 to 25 mm (0.12 to Choose the width of the left margin when media is loaded in the printer.
1.00 inch) Margin widths vary with the model of printer used. See "Printable area -
S70675/S50675" on page 123 or "Printable Area - S30675" on page 126.
0 to 800 mm (0.00 Adjust this parameter if you want to print from the near center of the
to 32.00 inch) media or if you want to shift the printed area left from the Side
Margin(Right) setting. The area between the right edge of the media
and Print Start Position is left blank. If a value is selected for Side
Margin(Right), an additional area corresponding to the width selected
for Side Margin(Right) will be left blank. Margin widths vary with the
model of printer used. See "Printable area - S70675/S50675" on page 123
or "Printable Area - S30675" on page 126.
On Choose whether the printer automatically detects (On), or does not
automatically detect (Off), the edges of the media. Try Off if the printer
Off
displays a Media Size Error when the media is correctly loaded. Note,
however, that the printer may print beyond the edges of the media when
Off is selected. Ink used outside the edges of the media will stain the
inside of the printer. We generally recommend to operate with this
setting set to On.
On Choose whether the printer automatically detects (On) or does not
automatically detect (Off), the end of the media. Try Off if the printer
Off
displays Media Out when the media is correctly loaded. We generally
recommend to operate with this setting set to On.
On When skewed media is detected, the printer will either stop printing and
display an error (On) or continue printing (Off). On is recommended in
Off
most circumstances, as skewed media may cause the printer to jam.
Using the Control Panel Menu
208