Table of Contents
Advertisement
Item
Heater Temperature
Drying Time Per Pass
After Heater Feed
Additional Dryer
Advanced Settings
Parameter
Pre-heater/platen heater:
30 °C to 50 °C
(86 °F to 122 °F)
After heater: 30 °C to 55 °C
(86 °F to 131 °F)
0 to 10sec
Mode 1
Mode 2
Off
On
Off
Explanation
The temperatures for the pre-, platen, and after heaters can each be
adjusted separately.
Select the time the print head pauses to allow drying after each pass.
Choose from values between 0.0 and 10.0 seconds. The time needed
for the ink to dry varies with ink density and the media used. If the
ink blurs on the media, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
To feed media to the after heater after printing, choose Mode 1 or
Mode 2; otherwise, choose Off.
If Mode 1 is selected, the portion fed for drying will not be rewound
before the next job starts. Select this option if the media will be cut
before the next job starts.
If Mode 2 is selected, the portion fed for drying will be rewound
before the next job starts, eliminating unnecessary margin. Select
this option if multiple jobs will be printed consecutively.
This item is displayed only when the additional print drying system
is installed (supplied with the S50675 and optional with other
models).
Select On to enable, or Off to disable, the optional additional print
drying system. Note that even when On is selected, the additional
print drying system will turn off with the heaters when the Heat Off
Timer expires. The additional print drying system will turn back on
when the heaters resume operation. See "The Printer Setup Menu"
on page 208.
During general use, use the default setting value without changing
it.
When using special media or when a problem such as head striking
or banding is detected in printing results, change the default.
Using the Control Panel Menu
206
Advertisement
Table of Contents
