Table of Contents
Advertisement
Important:
If the roll holder screw is loose, the roll holder may move during printing. This could cause
stripes and unevenness in the print results.
11. Rotate the handle until part A in the illustration below is fully inserted.
Important:
Once part A is hidden, do not turn the handle any further. Failure to observe this precaution
could damage the roll holder.
If part A is still visible even after the handle has been turned fully, rewind the handle.
Loosen the roll holder screw on the right side, and then restart from Step 9.
12. Raise the media loading lever.
47
Basic Operations
Advertisement
Table of Contents
