Table of Contents
Advertisement
*
When Media Size Check is set to Off, this is 1,626 mm (64 inches) regardless of the width of the loaded media.
1 to 4 indicates the margins on all four sides.
Margin
Explanation
Position
1
1 Bottom
This can be configured in a RIP. If the settings are outside the available range, they are
changed to 5 mm and 17 mm (0.2 and 0.7 inch) respectively to maintain media feeding
accuracy.
1
2 Top
This can be configured in a RIP. Differs by the length the media was pulled when the
media is loaded. For continuous printing, although the margins set in the RIP are added,
if the setting is less than 5 mm (0.2 inch), it is changed to 5 mm to maintain media
feeding accuracy.
2, 3
3 Left
The value selected for Side Margin(Left) in the printer's setup menu. The default setting
is 5 mm (0.2 inch).
2, 3
4 Right
The total of the values selected for Print Start Position and Side Margin(Right) in the
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm (0.2 inch).
1
The configured margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
2
This may be available in the RIP depending on the software RIP being used. Contact the RIP manufacturer for more
information.
Available
Setting Range
5 to 17 mm
(0.2 to 0.7 inch)
5 mm (0.2 inch)
or more
3 to 25 mm
(0.1 to 1 inch)
3 to 825 mm
(0.1 to 32.5
inches)
127
Basic Operations
Advertisement
Table of Contents
