Epson SureColor S30675 User Manual page 207

Item
Media Tension
Media Suction
Head Movement
Tension Measurement
Multi-Strike Printing
Feed Speed
Roll Type
Restore Settings
Parameter
0 to 40
0 to 10
Data Width
Printer Full Width
Periodically
Every Page
Off
Off
2 to 8
Auto
Lv1
Lv2
Printable Side Out
Printable Side In
Yes, No
Explanation
Increase tension if creases appear in the media during printing. The
higher the value, the greater the tension.
When media is waved on the platen, increase the Media Suction.
The higher the value, the greater the suction.
If graininess or out-of-focus characteristics are detected in printing
results obtained using thin or soft media or if the media is not fed
normally, reduce the Media Suction.
Choose the range in which the print head moves during printing.
Data Width restricts print head movement to the printed area.
Restricting the extent of print head movement increases print
speed.
If Printer Full Width is selected, the print head will move the full
width of the largest media supported by the printer. Select this
option for more even print results with less variation.
Choose Periodically or Every page to have the printer
automatically monitor and adjust media tension during printing for
optimal results, Off to disable automatic tension adjustment.
Periodically is recommended in most circumstances.
Selecting Every Page enhances the accuracy of the Tension
Measurement for the optimal adjustment, but the printing time is
longer than when Periodically is selected.
The printer may however be unable to adjust tension appropriately
for some media, resulting in excessive slack or other maladjustments
that cause printing problems, in which case you should select Off.
Note, however, that Off may result in unusually large margin
between pages. In addition, printing may not stop and the inside of
the printer may become stained. Observe the following precautions:
Do not print at the end of a roll
Do not select Off for Media End Check.
Choose the number of times each line is printed. For high-density
printing using backlight film, increase the frequency.
Auto is recommended in normal circumstances. If this option is set
to Auto, media is fed at the optimal speed depending on the
number of printing passes.
Select Lv1 for media that tends to stick together and for thin media
that is easily creased or torn.
Select Lv2 for faster printing. Note, however, that the feed speed will
not change if the number of passes is large.
This option is set based on the setting you selected when you
loaded the media.
If Yes is selected, configured media settings are returned to the
default.
Using the Control Panel Menu
207