Epson SureColor S30675 User Manual page 124

1 to 4 indicates the margins on all four sides.
Margin Explanation
Position
1
1 Bottom This can be configured in a RIP. If the settings are outside the available range, they are
changed to 5 mm and 17 mm (0.2 to 0.7 inch) respectively to maintain media feeding
accuracy.
1
2 Top This can be configured in a RIP. Differs by the length the media was pulled when the
media is loaded. For continuous printing, although the margins set in the RIP are added,
if the setting is less than 5 mm (0.2 inch), it is changed to 5 mm to maintain media
feeding accuracy.
2, 3
3 Left The value selected for Side Margin(Left) in the printer's setup menu. The default setting
is 5 mm (0.2 inch).
2, 3
4 Right The total of the values selected for Print Start Position and Side Margin(Right) in the
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm (0.2 inch).
1 The configured margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
2 This may be available in the RIP depending on the software. Contact the RIP manufacturer for more information.
3 Note the following points when setting margins:
Leave margins of 10 mm (0.4 inch) or more when using media holding plates. Narrower margins could result in the printer
printing over the plates.
If the total of the print data width and set left and right margins exceeds the printable area, a portion of the data will not
be printed.
Available
Setting Range
5 to 17 mm
(0.2 to 0.7 inch)
5 mm (0.2 inch)
or more
3 to 25 mm
(0.1 to 1 inch)
3 to 825 mm
(0.1 to 32.5
inches)
124
Basic Operations