Table of Contents
Advertisement
Getting Ready
1. Confirm that the printer is off.
2. Remove the waste ink bottle. See "Replacing the waste ink bottle" on page 167.
3. Disconnect the power cords and all other cables.
4. Remove media from the media feeding unit and auto take-up reel unit.
5. Unlock the stand.
Release the caster locks on the left and right legs and fully raise the adjusters.
6. Move the printer.
Important:
Use the casters on the dedicated printer stand to move the printer indoors a short distance
over a level floor. They can not be used for transportation.
Post-Move Setup
After moving the printer, follow the steps below to ready it for use.
1. Check that the new location is appropriate.
See the Setup Guide.
2. Plug in the power cables and turn the printer on.
See the Setup Guide.
3. Perform a nozzle check to check for clogged nozzles. See "Checking for Clogged
Nozzles" on page 181.
237
Appendix
Advertisement
Table of Contents
