Table of Contents
Advertisement
4 Epson LiftAssist lever
If the media to be mounted on the roll holders seems heavy, use these levers to raise the media effortlessly to the level of the
roll holders. There are two LiftAssist levers: one on the left and one on the right.
5 Pre-heater
Heats the media before printing so that the print area is not subject to sudden changes in temperature.
6 Roll support
Rest media on these supports before placing it on the roll holders. There are two supports: one on the left and one on the right.
7 Handle
After placing media on the right roll holder, rotate the handle to press the holder and apply pressure to the roll core.
LAN Port
1 RJ-45 connector
Connects the LAN cable. Use a shielded twisted pair cable (category 5 or higher).
2 Data lamp
The data lamp shows connection status and indicates whether the printer is receiving data.
3 Status lamp (green/red)
The status lamp indicates network connection speed.
Data lamp
On
Flashing
Status lamp (green/red)
On (green)
Status
The printer is connected using a
1000base-T connection.
The printer is receiving data over a
1000base-T connection.
19
Introduction
Advertisement
Table of Contents
