Epson SureColor S30675 User Manual page 125

Using high pressure rollers
When high pressure rollers are used for transparent or white film or ink layering, the
printable area is the area excluding the margins configured from the positioning of the
pressure rollers. (See the gray area in the illustration below.) The arrow indicates the feed
direction. The letter "A" indicates the position of the high pressure rollers.
1 to 4 indicates the margins on all four sides.
Margin Explanation
Position
1
1 Bottom This can be configured in a RIP. If the settings are outside the available range, they are
changed to 5 mm and 17 mm (0.2 to 0.7 inch) respectively to maintain media feeding
accuracy.
1
2 Top This can be configured in a RIP. Differs by the length the media was pulled when the
media is loaded. For continuous printing, although the margins set in the RIP are added,
if the setting is less than 5 mm (0.2 inch), it is changed to 5 mm to maintain media
feeding accuracy.
2, 3
3 Left The value selected for Side Margin(Left) in the printer's setup menu. The default setting
is 5 mm (0.2 inch).
2, 3
4 Right The total of the values selected for Print Start Position and Side Margin(Right) in the
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm (0.2 inch).
Available
Setting Range
5 to 17 mm
(0.2 to 0.7 inch)
5 mm (0.2 inch)
or more
3 to 25 mm
(0.1 to 1 inch)
3 to 825 mm
(0.1 to 32.5
inches)
125
Basic Operations