Table of Contents
Advertisement
Hold the tabs on the media holding plates and move the plates to the right and left sides
of the platen.
3. Loosen the roll holder fixing screws sufficiently and adjust the roll holders so that the
gap between the two is wider than the media.
Center the roll supports between the roll holders.
Important:
If the right holder handle shaft is not visible, rotate the holder forward until it stops. The
media can not be properly loaded if the handle shaft is not visible.
4. Place media on the roll support oriented according to how it is rolled (see below).
Printable side out
Printable side in
Basic Operations
66
Advertisement
Table of Contents
