Table of Contents
Advertisement
7 Caps
Except during printing, these caps cover the print head nozzles to prevent them from drying out. We recommend that the caps
be cleaned at the end of each workday.
See "Regular Cleaning" on page 137.
8 Wiper
The wiper removes ink from the print head nozzles. We recommend that this unit be cleaned at the end of each workday. It is
included in the maintenance kit and needs to be replaced about once every three months (or more often, depending on
usage).
See "Regular Cleaning" on page 137.
See "Cleaning the wiper cleaner and wiper rail (daily)" on page 148.
9 Flushing pad
Ink is discharged onto this pad during flushing. It is included in the maintenance kit and needs to be replaced about once every
three months (or more often, depending on usage).
See "Replacing the Flushing Pad" on page 172.
Back
1 Drive switch
The drive switch is used to feed the media during loading and to rewind the media for replacement.
2 Roll holder
Place media on these holders. There are two holders: one on the left and one on the right.
3 Roll holder fixing screw
These screws fix the roll holders in place once the media has been installed. There are two screws: one on the left and one on
the right.
18
Introduction
Advertisement
Table of Contents
