Epson SureColor S30675 User Manual page 209

Item
Warning Options
Warning Level Options
Auto Nozzle Check
Nozzle Check Cycle
Options When Clogged
Print Nozzle Pattern
Periodical Cleaning
Parameter Explanation
Off Choose whether the printer automatically detects (On) or does not
automatically detect (Off), the media lifting during printing.
On
If On is selected, the printer will stop when the media lifts to prevent a
head strike.
On is recommended if you will be performing other tasks and are unable
to give the printer your full attention during printing.
The printer may fail to detect the media lifting in the following instances
even when On is selected:
Off is selected for Media Size Check.
The Platen Gap is set to 2.5.
When printing patterns for Auto Media Adjust, Media Adjust, and Nozzle
Check.
When printing the job log, status sheets, and network settings.
When using transparent film or high-gloss media, media rise cannot be
detected even if this is set to On. If the media rubs against the print head
frequently, visually check the condition before you start printing.
1 to 5 The higher the value, the more sensitive the printer is to media lift.
Choose lower values to reduce the number of stoppages.
Off Choose the frequency with which the printer performs an Auto Nozzle
Check: never (Off) or once every 1 to 10 pages. Auto nozzle checks will
1 to 10 pages
not be performed while Off is selected. If 1 to 10 is selected, the printer
will automatically checks for clogs at the specified interval by scanning a
test pattern with a sensor as it is being printed.
Note that Auto Nozzle Check is not capable of detected all types of clog.
In addition, Auto Nozzle Check is not available depending on media
types or conditions.
See "Checking for Clogged Nozzles" on page 181.
Continue Printing Choose how the printer responds when an auto nozzle check detects
clogged nozzles.
Stop Printing
If Continue Printing is selected, the printer will display Nozzle Clog
Detected but keep printing. Perform head cleaning if you judge it
necessary on inspecting the print results.
See "Head Cleaning" on page 183.
If Stop Printing is selected, the printer will display Nozzle Clog
Detected and pause printing. Inspect the print results and choose
whether to resume or suspend printing according to the extent of the
clog.
Off Choose the frequency with which the printer prints a nozzle test pattern:
never (Off) or once every 1 to 10 pages. Periodic test patterns will not be
1 to 10 pages
printed while Off is selected. To print a test pattern at the top of every 1
to 10 pages, select an option between 1 and 10. When printing is
complete, you can visually inspect the pattern to determine whether
there may be faint or missing colors in the preceding or following
printout.
Using the Control Panel Menu
209