Epson SureColor S30675 User Manual page 226

❏ If the problem is not resolved, raise the setting value further.
Repeat Steps 2 and 3 until print results are improved.
If the measures above do not resolve the problem, continue with the next step.
5. Check the microweave (M/W) setting.
The microweave (M/W) setting may be inappropriate.
Refer to the microweave (M/W) setting and banding association table researched by
Epson, change the settings according to the media being used, and then check for
improvement. See "Microweave (M/W) Setting and Banding Association Tables" on
page 239.
Stains due to head striking
The media and print head are contacting during printing.
Perform the following sequence until he print results have improved.
1. Cut sections of media with wrinkles or waviness.
If media is stored inappropriately or left loaded in the printer, wrinkles and waviness
may occur. If media is used in this state, the print head and the raised surface of the
media may contact and cause staining. Cut sections with wrinkles or waviness before
using media.
Furthermore, store media as described in the manual accompanying the printer and
load media in the printer just before printing.
If the problem is not resolved even when printing on sections without wrinkles or
waviness, continue with the next step.
2. Load the media in the printer correctly and configure the media settings appropriately.
226
Problem Solver