Rear Remote Hydraulics (Optional) Or Switch Kit (Optional) Hydraulic Pump - Toro Sand Pro 3040 Service Manual

Rear Remote Hydraulics (Optional) or Switch Kit (Optional)
Hydraulic Pump
Refer to
Hydraulic Pump (page 5–114)
Removing the Optional Hydraulic Pump
Note: Refer to
1. Park the machine on a level surface, lower any attachments, set the key
2. You may want to remove the hitch assembly to improve access to the
3. Read and adhere to the information provided in
4. Clean the hydraulic pump and all hydraulic connections to prevent hydraulic
5. Disconnect the hydraulic hoses from the fittings on the hydraulic pump and
6. Install clean caps or plugs on the fittings and in the disconnected hoses to
Hydraulic System: Service and Repairs
g353005
(rear remote hydraulics kit shown with hitch removed)
1. Square key
2. Rubber bushing
3. Coupler
4. Set screw (4 each)
5. Flange nut (2 each)
6. Square key
Servicing the Optional Rear Remote Hydraulics or Optional Switch Kit
Figure 71
switch to the O position and remove the key from the switch.
FF
optional hydraulic pump; refer to
(page 7–22).
Removing and Installing the Hydraulic System Components (page
system contamination.
allow the hydraulic lines to drain into a suitable container.
prevent contamination.
Page 5–112
Figure 71
7. Barb fitting – suction
8. Hose clamp
9. Cap screw (2 each)
10. Hydraulic pump
11. Elbow fitting
12. Torque arm
for pump service information.
for this procedure.
Removing and Installing the Hitch Assembly
13. Cap screw (2 each)
14. Washer (2 each)
15. Bracket
16. Suction hose
17. Hydraulic hose
General Precautions for
5–54).
Sand Pro ® 3040 and 5040
20251SL Rev A