Headlight Switch - Toro Workman HDX Auto Service Manual

Table of Contents

Advertisement

Headlight Switch

This headlight switch allows the headlights to be turned
on and off. The headlight switch is located on the dash
(Fig. 11).
Testing
1. Park machine on a level surface, stop engine, apply
parking brake and remove key from ignition switch.
2. To ease access to headlight switch, remove hood of
vehicle (see Hood in the Service and Repairs section of
Chapter 5 − Chassis).
3. Locate headlight switch on dash and disconnect wire
harness electrical connector from the switch.
4. With the use of a multimeter (ohms setting), the
headlight switch functions may be tested to determine
whether continuity exists between the various terminals
for each switch position. The switch terminals are
marked as shown in Figure 12. The circuitry of this
switch is shown in the chart below. Verify continuity be-
tween switch terminals for each switch position.
SWITCH
POSITION
ON
OFF
5. Replace headlight switch if testing proves it to be
faulty.
6. After testing, connect wire harness electrical connec-
tor to the headlight switch.
7. Install hood if it was removed (see Hood in the Ser-
vice and Repairs section of Chapter 5 − Chassis).
Electrical System
NORMAL
OTHER
CIRCUITS
CIRCUITS
2 + 3
5 + 6
1 + 2
4 + 5
1
2
1. Dash
Page 6 − 12
Figure 11
2. Headlight switch
BACK OF SWITCH
Figure 12
Workman HDX Auto

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

07390

Table of Contents