Left Side - Sony SRW-9000 Operation Manual

g Lens mount
Attach the lens. When no lens is mounted, keep
the lens mount cap fitted for protection from dust.
For details, see "Mounting the Lens" (page 30).

Left Side

Shoulder pads
a Cassette insertion slot
Insert cassettes.
For details, see "Loading and Unloading Cassettes"
(page 80).
b CTRL (VTR) (control panel) connector
Connect the cable of the supplied control panel. A
short cable is connected when the unit is shipped
from the factory. You can exchange the short
cable for the supplied extension cable.
For details, see "Attaching the Control Panel" (page
36).
c Measure hook/focus reference mark (φ)
For actual measurement of the distance from a
subject, you can fix the end of a tape measure to
the hook.
A mark on the side panel (φ) indicates the
reference focus position.
d CTRL (CAM) (assistant panel)
connector
Connect the cable of the optional AP-1 Assistant
Panel.
For details, see "Attaching the AP-1 Assistant Panel
(Optional)" (page 38).
16 Locations and Functions of Parts
e Power ON (])/OFF (1) switch and
indicator
Push the switch to the ON side to power the unit
on (the indicator lights). Push it to the OFF side to
power the unit off (the indicator goes out).
f EARPHONES jack and LEVEL knob
Use the jack to attach earphones or stereo
headphones equipped with a stereo miniplug, for
use in monitoring audio during recording and
playback. Adjust the audio level with the LEVEL
knob.
A warning sound is heard through the earphones
or headphones when an error occurs.
Note
Some L-type mini plugs cannot be connected. Use a
straight type mini plug.
For details on the warning tone, see "Warning
System" (page 183).
g AUDIO indicator
Lights when the audio level meters (see page 25)
exceed a certain level.
h HD SDI MON1 (HDSDI monitor output
1) connector (BNC type)
Output HDSDI signals for display on a monitor.
You can select/set the output signals in the
Camera menu (see page 56). The same signals are
output from the HD SDI MON2 connector on the
rear panel.
i EXT I/O (external control) connector
(5-pin)
Use the connector for control via RS-232C.