Optical Filters - Sony SRW-9000 Operation Manual

The indication begins to flash if the voltage
decreases to the NEAR END value specified on
the <BATT ALARM SET> page of the Camera
>MAINTENANCE menu. The flashing becomes
quicker when the voltage decreases further and
approaches the END value. You can check the
NEAR END and END values on the <BATTERY
ALARM> page of the Camera >USER
(OPERATION) menu and on the SYSYTEM
Setup >BATTERY of the VTR menu.
e Focus position
Shows the focus position of a zoom lens as a
numeric value in the range 0 to 255 (infinity).
f Zoom position
Indicates the approximate position of the zoom
lens variator between wide angle (0) and
telephoto (99).
g White balance memory
Displays the currently selected white balance
memory.
W:A: Memory A
W:B: Memory B
W:P: Preset memory
The setting is fixed at W:P in Cine mode.
In Custom mode, you can change the setting
using the subdisplay or from a remote control
unit.
h Color temperature filter mode
Indicates the state of the electrical filter.
In Cine mode, "5600" is displayed when the
daylight filter is selected. When the tungsten filter
is selected, this column becomes blank.
In Custom mode, "5600" is displayed when CC:C
(5600K) filter is set to ON.
i Optical filters
Displays the types of currently selected two
filters. The number (1, 2, 3, 4, or 5) indicates the
ND filter, and the letter (A, B, C, or D) is for the
CC filter.
The letter E appears when the
selected.
j Gain value
Displays the video gain value (dB) of the video
amplifier.
1
/ ND filter is
2
Viewing Settings and Indications in the Viewfinder
k Shutter
Displays the shutter setting as a shutter angle or
speed. For a shutter angle,
left.
The type of the display, angle (deg) or speed
(sec), can also be switched on the <VF
DISPLAY> page of the Camera >USER
(OPERATION) menu (default: deg).
l Audio level meters
The upper row displays the maximum levels for
odd-numbered channels. The lower row displays
the maximum levels for even-numbered
channels.
m Tape remaining
Indicates the approximate remaining tape time in
minutes.
n F value
Indicates the lens f-stop (iris opening) value.
o Self-diagnosis information
If an error occurs on an internal board or
elsewhere, "CAM?" appears here, and an error
message appears in the message area.
This indication cannot be turned off.
For the error messages, see "Warning/Error
Messages" (page 185).
p Message area
Displays the status of auto setup processing, error
messages, and so on.
For the error messages, see "Warning/Error
Messages" (page 185).
q Timecode area
Displays the same timecodes as the subdisplay.
For details, see "Checking Timecode and the
Remaining Tape Time" (page 49).
To select the basic status indications
You can use the <VF DISPLAY> page of the
Camera >USER (OPERATION) menu to select
the basic status indications that you want appear
in the viewfinder.
is displayed at the
61