Specifying And Displaying Markers - Sony SRW-9000 Operation Manual
Hd camcorder
Hide thumbs
Also See for SRW-9000:
- Operation manual (221 pages) ,
- Brochure & specs (8 pages) ,
- Operation manual (177 pages)
Table of Contents
Advertisement
Specifying and Displaying
Markers
You can display various markers, such as the
center marker and safety zone marker, on the
viewfinder and monitor screens.
Example: Center marker (entire cross)
Example: Safety zone marker (90%)
The <CHAR/MARK MIX> page and
<MARKER SETTING> page of the Camera
>USER (OPERATION) menu allow you to
switch the display of the markers on or off and to
specify the appearance, and parameters of the
markers.
Activating/deactivating marker display
on each output
The <CHAR/MARK MIX> page allows you to
activate and deactivate the display of markers on
each output.
<CHAR/MARK MIX> page
The display of markers (MARKER) is set to ON
for all outputs when the unit is shipped from the
factory.
Item
Setting
VF
Turn all the markers on or off in the
viewfinder.
MON
Turn the markers on or off on the
monitors connected via the HD SDI
MON1 or HD SDI MON2 connector.
HD-Y
Turn the markers on or off on the
monitors connected to the HD SDI OUT
A/B connectors (when the HKSR-9001
is installed).
VBS
Turn the markers on or off on the
monitors connected via the TEST OUT
and REMOTE connectors.
The CHAR/MARK LEVEL line allows you to
adjust the brightness (0 to 50) of the character and
marker indications.
Specifying the markers to be displayed
The <MARKER SETTING> page allows you to
select the markers that you want to display.
The selected markers will appear on an output if
marker display for that output has been activated
on the <CHAR/MARK MIX> page.
<MARKER SETTING> page
All the markers have been set to OFF at the
factory.
Page 64
Advertisement
Table of Contents
