Assignable buttons/switch
The unit is equipped with 10 assignable buttons/
switch on the side panel. For easier operation
during shooting, you can assign frequently used
functions to these switches. You can also assign
basic VTR control functions such as STOP,
PLAY, and REW, which allows you to control
tape transport without using the control panel.
Rich Selection of Functions
Two operation modes: Cine and Custom
This unit offers two operation modes: Cine mode,
for film-like shooting, with adjustments normally
being made in post production, and Custom
mode, for users who wish to obtain a specific look
by adjusting parameters on the set.
Monitor output functions
The unit provides a wide range of monitor output
functions, including mixing of characters and
markers into monitor output, mixing of camera
and playback video, and separate gammas for
monitor and main line.
Down converter
A down converter is provided as a standard
feature, allowing you to monitor camera and VTR
playback video as SD composite on an SD
monitor.
1.5G Dual link output
Installation of the optional HKSR-9001 in this
unit enables output of 1.5G Dual Link signals
(RGB 4:4:4 or 4:2:2 1080/50P).
3G HDSDI output
Installation of the HKSR-9001 enables output of
3G Single Link signals, equivalent to 1.5G Dual
Link signals, over a single BNC cable.
1)
SR Motion™
When the optional HKSR-9002 Picture Cache
Board is installed, SR Motion is available on this
unit. SR Motion allows you to obtain effects
similar to overcranking and undercranking on
film cameras by using HKSR-9002’s built-in
memory while maintaining the high picture
quality of HDCAM-SR (1920 × 1080) format.
SR Motion is available in Select FPS mode.
Select FPS enables variable-speed motion effects
by changing the frame frequency during
recording (Ramp function).
1) SR Motion is a trademark of Sony Corporation.