Warning System - Sony SRW-9000 Operation Manual

Warning System

When an error is detected immediately after the unit is powered on, or during operation, an message
appears (see A in the following table) on the viewfinder screen, on an external monitor, in the subdisplay
on the right-side panel, and in the control panel display, and the tally indicator (see page 19) flashes (see
B in the following table) to alert you to the error. In addition, warning and alarm tones are output from the
EARPHONES jack and the buzzer mounted on a circuit board inside the unit (see C and D in the following
table).
Notes
• Warning tones are not output unless BEEP(PHONE)/BEEP(BOARD) >WARN in the VTR >AUDIO Setup menu (see
page 162) is set to HIGH or LOW.
• Alarm tones are not output unless BEEP(PHONE)/BEEP(BOARD) >ALARM in the VTR >AUDIO Setup menu (see
page 162) is set to HIGH or LOW.
Layout of the table of warning messages
Message Tally indicator
A B
Problem Operation on the VTR module
• The operation of the tally indicator is represented by graphic symbols as follows.
: 1 flash/s
: 4 flashes/s
• The warning and alarm tones are represented by graphic symbols as follows.
: 1 beep/s
: 4 beeps/s
: Continuous beep
Warning indications/tones
Message Tally indicator
See "Warning –
messages" (page 188).
Problem Operation on the VTR
module
A warning message Continues operation.
condition occurred
(except "0060 LOST
LOCK" described
below).
Message Tally indicator
0060 LOST LOCK
Problem Operation on the VTR
module
Servo lock lost during Recording continues, but
recording. the results may be invalid.
Warning tone
–
Action to take
Check the warning message, and resolve the condition,
referring to the "Description" column in the table of
"Warning messages" (page 188).
Warning tone
a)
Action to take
Turn off the power and contact a Sony service
representative.
Warning tone Alarm tone
C D
Action to take
Alarm tone
–
Alarm tone
b) –
Warning System 183