Locations And Functions Of Parts; Front Panel - Sony SRW-9000 Operation Manual

Locations and Functions
of Parts

Front Panel

a VF (viewfinder) connector (20-pin)
Connect an optional viewfinder.
b Viewfinder shoe
Attach an optional viewfinder. You can adjust the
attachment position up and down.
For details, see "Attaching the Viewfinder" (page
32).
c Filter selector
The selector knobs switch between the unit's
built-in filters.
Filter selector (outer knob) settings and optical
CC (color conversion) filter selection
Setting knob CC filter selection
A 3200K
B 4300K
C 5600K
D 6300K
E
ND 0.3 (
Filter selector (inner knob) settings and ND filter
selection
Setting knob ND filter selection
1 CLEAR
2
ND 0.6 (
3
ND 1.2 (
4
ND 1.8 (
5 CAP
You can use the filter label on the right side panel
to check the filters that are selected by the various
knob positions.
When this selector is used, the new setting
appears on the viewfinder screen for about three
seconds.
When the optional HKSR-9004 is installed, filters
can be electrically switched by the subdisplay or
the switch to which you have assigned the filter
switching function.
For details, see "Adjusting the White Balance (in
Custom Mode)" (page 55).
d LENS connector (12-pin)
If you mount an optional lens with a cable,
connect the cable to this connector. You can
control the functions of the lens through this
connector.
Note
Do not connect a device whose maximum rated current
is 1 A or higher to the LENS connector.
e Lens mount cap
Cover the lens mount with this cap when a lens is
not attached. The cover may be removed by
rotating the lens fixing lever upward.
f Lens fixing lever
Push the lever downward to secure the lens in the
lens mount. To remove the lens, pull up on the
lever.

Locations and Functions of Parts

1
/ ND)
2
1
/ ND)
4
1
/ ND)
16
1
/ ND)
64
15