Display Settings; Detailed Video Format Settings; Setting The Video Format In The Camera Menu - Sony SRW-9000 Operation Manual

Display Settings

The display of the control panel displays VTR
menus and information such as audio levels,
warnings, operating status indications, time data,
remaining tape capacity, and remaining battery
capacity.
For details, see "Display" (page 24).
If the display is hard to see because of low light
conditions, you can set the LIGHT switch to ON
to turn on the backlight.
Use the VTR menu to make display settings.
For details on menu operations, see "VTR Menu
Operations" (page 155).
To make the backlight brighter
Select LCD >BRIGHT in the SYSTEM Setup
menu (see page 164) and adjust the brightness (0
to 31) in the Backlight Brightness window.
To turn the backlight off after a specified
interval
Select LCD >LIGHT OFF in the SYSTEM Setup
menu (see page 164) and select the time that the
backlight should remain on (5 sec to 5min) in the
Backlight Off Timer window.
To keep the backlight on, select "Disable".
To display a screen saver after a
specified interval
Select LCD >SAVER in the SYSTEM Setup
menu (see page 164) and select the time after
which the screen saver should appear (1min to
1hour) in the Screen Saver window.
Select "Disable" if you do not want to display a
screen saver.
LIGHT switch
Detailed Video Format
Settings
On this unit, you can select the video formats
listed in the following table.
Frame rate Signal format
23.98PsF YCbCr 4:2:2
RGB 4:4:4
24PsF YCbCr 4:2:2
RGB4:4:4
25PsF YCbCr 4:2:2
RGB4:4:4
29.97PsF YCbCr4:2:2
RGB4:4:4
50P YCbCr 4:2:2
59.94P YCbCr 4:2:2
59.94I YCbCr 4:2:2
RGB 4:4:4
50I YCbCr 4:2:2
RGB 4:4:4
You can check the currently selected format in the
SYSTEM screen (page 63).
You can register eight of your most frequently
used formats from the above list, which allows
you to select them on the subdisplay.
For format selection on the subdisplay, see
"Selecting the Video Formats" (page 46).
Setting the Video Format in the
Camera Menu
You can set the video format on the <OUTPUT
FORMAT> page of the MAINTENANCE menu.
The factory default settings are the 23.98PsF
frame rate and the 4:2:2 YCbCr signal format.
Referring to the procedure mentioned in "Setting
the Built-in Clock" (page 39), select
MAINTENANCE menu on the TOP MENU
screen and call up the <OUTPUT FORMAT>
page.
For details on menu operations, see "Basic Camera
Menu Operations" (page 113).
Display Settings / Detailed Video Format Settings
Bit length
10
10 or 12
10
10 or 12
10
10 or 12
10
10 or 12
10
10
10
10 or 12
10
10 or 12
75