Sony SRW-9000 Operation Manual page 163

Item
FORMAT
Signal format settings
Settings
LINE Sets the number of effective lines and the scanning system.
1080I [1080I]
1080P [1080PsF/P]
FRAME When SELECT FPS is set to "OFF", sets the operation
frame frequency.
When SELECT FPS is set to "ON", sets the target frame
frequency.
23.98 [23.98]: Frame frequency 23.976 Hz
24 [24]: Frame frequency 24 Hz
25 [25]: Frame frequency 25 Hz (field frequency 50 Hz)
29.97 [29.97]: Frame frequency 29.97 Hz (field frequency
50 [50]: Frame frequency 50 Hz
59.94 [59.94]: Frame frequency 59.94 Hz
For more information, see "Using the Select FPS Function"
(page 104).
SIGNAL Sets the sampling method and video signal recording rate.
422 [4:2:2]: 4:2:2 (Y/Pb/Pr), 440 Mbps (880 Mbps for 50P
444SQ [4:4:4 SQ]: 4:4:4 (R/G/B), SQ mode, 440 Mbps
444HQ [4:4:4 HQ]: 4:4:4 (R/G/B), HQ mode, 880 Mbps,
444 12 [4:4:4 HQ 12bit]: 4:4:4 (R/G/B), HQ mode, 880
Note
Tapes recorded with the 444HQ or 444 12 setting cannot be
played back on the SRW-5000/5500. Also, certain limitations
apply to when tapes recorded in other 880 Mbps formats are
played back on the SRW-5000/5500.
For details, see "About Recording/Playback Formats"
(page 193).
SELECT FPS When the HKSR-9002 is installed, selects the operating
mode of the Select FPS function.
OFF [Off]: Do not use the Select FPS function.
ON [On]: Enable Select FPS function with frame rate (FPS)
For details on the settings, see "Select FPS Function" (page
103).
Note
To record 4:4:4 SQ 50P/59.94P format signals, the optional
HKSR-9002 must be installed, and SELECT FPS must be set to
"ON".
59.94 Hz)
or 59.94P)
(880 Mbps for 50P or 59.94P)
bit length 10
Mbps, bit length 12
set on the subdisplay, control panel, or optional AP-1
Assistant Panel.
VTR Menu List 163