Making Timecode And User Bits Settings - Sony SRW-9000 Operation Manual

Turn clockwise to raise the level and turn
counterclockwise to lower it.
To reset the setting
Turn the SELECT/ENTER dial to move the
cursor to RESET, and press the dial.
5
Press the SELECT/ENTER dial.
6
Repeat steps 1 and 2 to select other
channels and steps 3 and 4 to set the
recording levels of those channels.
7
When you are finished, turn the
SELECT/ENTER dial to select END,
and press the dial.
Making Timecode and User Bits
Settings
Use the VTR >TC Setup menu to make timecode
and user bits settings.
To display the TC Setup menu
Press the menu selection button "TC".
TC button
TC Setup menu screen
Control panel
To select the type of time data to display
Use the TIMER SEL item.
1
Turn the SELECT/ENTER dial to
select CTL, TC (timecode), or UBIT
(user bits).
2
To select timecode to record
You can select the following types of timecode.
Menu item
TCG
MODE
PRST
RGN
SELECT/
ENTER dial
a) Only when the HKSR-9001 is installed
To select user bits to record
You can select the following types of user bits.
Menu item
OTHERS
(MAIN)
>RT REC
OFF
CTL: Display CTL signals.
TC: Display timecode.
UBIT: Display user bit data.
Press the SELECT/ENTER dial.
Timecode
REGENE
SOURCE
– An arbitrary initial
timecode value can be
preset (R RUN/F RUN
and DF/NDF menu
items can be set to any
values).
INT L Timecode in
synchronization with
the timecode recorded
in the longitudinal
direction on the tape.
EXT L Timecode in
synchronization with
the timecode input to
the TC IN connector.
a) Timecode in
AUX L
synchronization with
the LTC timecode of the
SDI signal input to the
AUX IN connector.
a) Timecode in
AUX V
synchronization with
the VITC timecode of
the SDI signal input to
the AUX IN connector.
TCG TCG
SET MODE
(MAIN)
>UBG
SOURCE
TCG PRST
User bits
Arbitrary user bits
can be preset
(TIMER PRESET
>TCG UBIT).
Recording 85