Sony SRW-9000 Operation Manual page 106

2 Set the number of frames to be shot
(FPS value).
3 Start recording. During recording,
change the FPS value as required by
Turning the SELECT/ENTER dial.
4 Stop recording.
4
Conduct a review.
1 Rewind to the timecode position that
you noted in step 3 1.
2 Set SELECT FPS in the SYSTEM
Setup >FORMAT menu to "OFF" to
set the playback timecode to 24
frames/sec (the target frame frequency
to 23.98PsF).
3 Press the SET button to switch the
format.
4 Press the PLAY button to start
playback.
You can check the slow or quick motion
effect at the target frame frequency of
23.98PsF. The timecode advances from 0 to
23 frames per second. You can also review
the recording by using simple playback
without checking the slow or quick motion
effect.
For more information about simple playback,
see the next section "To perform simple
playback without checking motion effects".
Notes
• Audio cannot be recorded normally when SR Motion
is used for shooting.
• When the FPS is set to a lower value than the value set
for FPS FORMAT (system frame frequency),
recording to the tape proceeds in starts and stops,
because data is recorded only when a certain amount
has been accumulated in the unit's internal memory.
To perform simple playback without checking
motion effects
Simple playback allows you to check recorded
video in fewer steps than normal playback.
Simple playback does not use the specified target
frame frequency, so it does not allow you to check
slow or quick motion effects.
1
Set the number of frames to shoot (FPS
value).
106 Select FPS Function
2
Start recording. During recording,
change the FPS value as required.
3
Stop recording.
4
While holding the FUNC button down,
press the PLAY button.
This starts a recording review. The unit
rewinds the tape for three seconds and then
starts playback of the scene you have just
shot. When playback ends, the unit enters
recording pause mode at the point where
recording ended.
To check more than three seconds earlier
If you hold down the FUNC button while
pressing the PLAY button for three seconds
or more, the unit rewinds as long as you keep
the buttons held down. If the setting of
SERVO >REC REVIEW in the SYSTEM
Setup menu is "NORM", you can rewind up
to 10 seconds. If the setting is "ALL", you
can hold down the FUNC button and press
the PLAY button once. The unit will rewind
to the start of the most recently recorded cut
and start playback.
Formats available for Select FPS
shooting
Note
The 4:4:4 format is not available when the scan method
is progressive and the target frame frequency is 50 Hz or
higher.
The following table shows the combinations of
setting items in the SYSTEM Setup >FORMAT
menu.
a: Available
z: Not available