Left Side - Sony SRW-9000 Operation Manual

Filter selector (outer knob) settings and optical
CC (color conversion) filter selection
Setting knob CC filter selection
A 3200K
B 4300K
C 5600K
D 6300K
E
ND 0.3 (
Filter selector (inner knob) settings and ND filter
selection
Setting knob ND filter selection
1 CLEAR
2
ND 0.6 (
3
ND 1.2 (
4
ND 1.8 (
5 CAP
You can use the filter label on the right side panel
to check the filters that are selected by the various
knob positions.
When this selector is used, the new setting
appears on the viewfinder screen for about three
seconds.
For details, see "Adjusting the White Balance (in
Custom Mode)" (page 51).
d LENS connector (12-pin)
If you mount an optional lens with a cable,
connect the cable to this connector. You can
control the functions of the lens through this
connector.
Note
Do not connect a device whose maximum rated current
is 1 A or higher to the LENS connector.
e Lens mount cap
Cover the lens mount with this cap when a lens is
not attached. The cover may be removed by
rotating the lens fixing lever upward.
f Lens fixing lever
Push the lever downward to secure the lens in the
lens mount. To remove the lens, pull up on the
lever.
g Lens mount
Attach the lens. When no lens is mounted, keep
the lens mount cap fitted for protection from dust.
For details, see "Mounting the Lens" (page 29).
1
/ ND)
2
1
/ ND)
4
1
/ ND)
16
1
/ ND)
64
a Cassette insertion slot
Insert cassettes.
For details, see "Loading and Unloading Cassettes"
(page 76).
b CTRL (VTR) (control panel) connector
Connect the cable of the supplied control panel. A
short cable is connected when the unit is shipped
from the factory. You can exchange the short
cable for the supplied extension cable.
For details, see "Attaching the Control Panel" (page
35).
c Measure hook/focus reference mark (φ)
For actual measurement of the distance from a
subject, you can fix the end of a tape measure to
the hook.
A mark on the side panel (φ) indicates the
reference focus position.
d CTRL (CAM) (assistant panel)
Connect the cable of the optional AP-1 Assistant
Panel.
For details, see "Attaching the AP-1 Assistant Panel
(Optional)" (page 37).

Left Side

Shoulder pads
connector
Locations and Functions of Parts 15