Usb Connector - Sony PDW-700 Operation Manual

• This connector also inputs a return video signal.
You can display the HD-Y signal in the
viewfinder screen while holding the RET button
down with RETURN VIDEO set to ON on the
ASSIGNABLE SW page of the OPERATION
menu.
e TC IN (timecode input) connector
(BNC type)
To apply an external lock to the timecode of this
unit, input the reference timecode.
For details of timecode, see "Setting the timecode"
on page 64.
f TEST OUT connector (BNC type)
This connector outputs the video signal for a
video monitor. The output signal can be selected
from composite video, HD-Y, R, G, B, and a
composite video signal like that displayed in the
LCD monitor. To switch output signals, use the
TEST OUT SELECT item on the OUTPUT 1
page of the OPERATION menu.
If the output signal is set to one of R, G, or B, then
this setting changes to HD-Y when the camcorder
is powered off and on again.
Depending on menu settings, menus, time code,
and shot data can be superimposed on the image
on the monitor. This connector can also be used to
synchronize the time code of an external VTR
with the time code of the camcorder.
g TC OUT (timecode output) connector
(BNC type)
To lock the timecode of an external VTR to the
timecode of this unit, connect this connector to
the external VTR's timecode input connector.
Rear
5 6
8 9 0
a TALLY (back tally) indicator (red)
Lights up during recording. It will not light if the
TALLY switch is set to OFF. This indicator also
flashes to indicate warnings (see page 20) in the
same manner as the REC/TALLY indicator in the
viewfinder.
For details, see "Operation Warnings" on page 190.
b TALLY switch
Set to ON to activate the TALLY indicator
function.
c USB connector
This is a USB 2.0 connector for maintenance.
Note
Do not connect USB devices to this unit for any purpose
other than maintenance.
d
(network) connector (RJ-45 type)
This is a 10BASE-T/100BASE-TX connector for
network connection.
Locations and Functions of Parts and Controls
1
2
3
4
7
qa qs qd
27