Ruckus Wireless ZoneFlex 7982 User Manual page 99

NOTE: If you are using a ZoneFlex 7363/7962/7982 AP, go to Configuration > Radio
2.4G or Configuration > Radio 5G.
2. Click the Wireless # tab for which you want to configure the access control
settings.
3. Click the Edit Settings button next to Access Control.
4. Select the radio button for the desired access control. (For a description of the
options, see "Access Control Options"
Controls Table appears.
5. To add a MAC address to the Access Control table, click the Add new entry
button.
6. Fill out the following text boxes:
• Address: Six text boxes appear in which you enter the desired MAC address,
in hexadecimal digit form, two characters in each box. You can specify a full
12-hex-digit MAC address or enter "wildcard" characters for "don't care"
digits. Allowable hex-digit characters are 0-9, a-f, and A-F. Most address-tags
and software where you find MAC addresses listed include colons or dashes
to separate the address-pairs; that is provided for you on the web page, so do
not enter the colons or dashes.
Supported wildcard characters include "x", "X" and blank (space character).
Wildcards are useful when you want to specify all MAC addresses from a given
manufacturer. For example, by specifying only the Organizationally Unique
Identifier (the first six hexadecimal digits of any MAC address from that
manufacturer is its OUI) saves you having to enter all 24 million of them (the
table size is limited in the AP/Router to 128 entries). Some manufacturers
produce devices using more than one OUI, in which case you may need to
enter each applicable one.
7. Click Update to save your changes. Assuming all parameters you entered are
acceptable, that row will be added to the table.
You have completed adding an entry to the MAC address table. If you have additional
MAC addresses you want included, click Add new entry, and then repeat these steps
until you have entered all the stations you want. There is a limit of 128 rows.
Removing a MAC Address
To remove a MAC address from the ACL table, click the Cancel button under the
Remove column, and then click Update. The ACL table refreshes, and the MAC
address that you deleted disappears from the table.
Configuring the Access Point
Configuring Wireless Settings
in the previous section.) The Access
91