Ruckus Wireless ZoneFlex 7982 User Manual page 81

Wireless Mode
Channel
Channel Width (11n APs only)
Country Code
Advanced Settings
AeroScout RFID
On 802.11b/g APs:
The wireless mode options include the following:
• Auto-Select: Allows both 802.11g- and
802.11b-compliant devices to connect to the
network. This is the default setting.
• 2.4GHz 54 Mbps (For faster 802.11g devices
only): Allows only 802.11g-compliant devices to
join the network.
• 2.4GHz 11Mbps (For slower 802.11b devices
only): Allows only 802.11b-compliant devices to
join the network.
On dual radio 802.11n APs:
On dual radio 802.11n APs, the wireless mode is
determined by radio; i.e., for the 2.4GHz radio, the
mode is set to 2.4GHz (802.11b/g/n), while for the
5GHz radio, the mode is set to 5GHz (802.11a/n).
On ZoneFlex 7321:
ZoneFlex 7321 is a single radio 802.11n AP
capable of operating in either 2.4 or 5GHz mode.
Use this setting to select 2.4GHz or 5GHz mode.
See "Band Selection on ZoneFlex
This option lets you select the channel used by the
network. You can choose SmartSelect, or choose
one of a specific number of channels. If you
choose SmartSelect, the AP automatically selects
the best channel (encountering the least
interference) to transmit the signal.
On 802.11n Access Points, the option to choose
40MHz channel width provides (theoretically)
double the data capacity of the channel. However,
wider channel width means fewer channels
available, and more interference with other
wireless signals.
This option (if enabled) lets you select your
country or region code.
Refer to "Reviewing Common Advanced
Settings" on page 75.
Select Enabled to enable AeroScout RFID tag
detection.
Configuring the Access Point
Configuring Wireless Settings
7321".
73