Running Diagnostics - Ruckus Wireless ZoneFlex 7982 User Manual

Managing the Access Point

Running Diagnostics

2. Click Reset Now (next to Restore to factory settings?).
3. When the confirmation warning appears, read the message and click OK if you
are certain that you want to restore the AP to factory defaults.
After a brief pause, you will be automatically logged out of the AP. You must now
disconnect the AP from the switch (and the network) and reconnect it to your
computer, as described in
time, you can restore the network settings, then replace it in your site for full network
use.

Running Diagnostics

Two network connection diagnostic tools – PING and traceroute – have been built
into the AP to help you check network connections from the Web interface.
To run diagnostics for network troubleshooting
1. Go to Administrator > Diagnostics. The Administrator > Diagnostics page
appears. Two options are available:
• Ping
• Traceroute
2. Click the text field by the option you want to activate, and type the network
address of a site you wish to connect to.
3. Click Run Test.
The results appear in the text field below each option.
"Step 1: Preconfigure the Access Point" on page 42. At this
124