Electro-Hydraulic Remote Control Valves; Remote Valve Isolator Switch - New Holland T6010 Operator's Manual

ELECTRO- -HYDRAULIC REMOTE
CONTROL VALVES (where fitted)
NOTE: The Electro- -hydraulic remote valves are
only available in conjunction with the Enhanced
keypad.
The electro--hydraulic remote valves operate in a
similar manner to the mechanical valves previously
described. However, with these remote valves, a
number of additional automated functions are
available, supported by visual displays in the Dot
Matrix screen.

Remote Valve Isolator Switch

The remote valves cannot be operated unless the
system is energised using the isolator switch (1).
Depress the lower part of the switch to activate the
electrical circuit, depress the upper part to
de--activate. When activated, the amber warning
light (2) will be illuminated. The remote valve(s) are
now operational whenever the tractor engine is
running.
IMPORTANT:The isolator switch may be used to
immediately stop operation of the rear remote valves
by depressing the top of the switch. The isolator
switch will only control the remote valves, it has no
effect on three point linkage operation.
Control Levers
Each remote valve lever has four positions, extend,
neutral, retract, and float. In extend and retract
modes, the detented positions are used for timed
remote valve functions.
Pull the lever back from the neutral position, (N), to
the "extend" (Raise) position, (R). From neutral, push
forward to the "retract" (Lower) position, (L). Push
the lever fully forward to the Float position, (F). Float
will permit the cylinder to extend or retract allowing
equipment such as scraper blades to "float" or follow
the ground contour.
The "float" position is also used for retracting a
single-acting cylinder and is the OFF position for
hydraulic motors.
SECTION 3 - - FIELD OPERATION
120
121
3--69