Pre-Operation Settings - New Holland T6010 Operator's Manual

PRE- -OPERATION SETTINGS
Attach the implement to the 3--point linkage.
Turn the draft loading wheel (2) fully forward to
position 10 -- this is the Position Control setting.
Start the engine and, using the Position Control lever
(1), raise the implement in stages, ensuring that
there is at least 100 mm (4 in.) clearance between the
implement and any part of the tractor. Note the digital
display reading on the instrument panel. If the
reading is less than '99' it means that the implement
is not fully raised.
Adjust the height limit control knob (2) to prevent the
linkage being raised further and so avoid the
possibility of the implement damaging the tractor
when fully raised.
When the raise/lower switch or the Position Control
lever is used to raise the implement, it will only raise
to the height set by the height limit control, as
determined in the previous step.
Adjust the rate of drop, to suit the size and weight of
the attached implement, by rotating the drop rate
control knob (1). Turn the knob clockwise to speed up
the drop rate or anti-clockwise to slow down the drop
rate.
IMPORTANT: When first setting the implement up
for work, keep the drop rate control knob in the slow
drop position ('tortoise' symbol).
When the raise/lower switch is used to lower the
implement, it will lower at a controlled rate as
determined in the previous step.
SECTION 3 - - FIELD OPERATION
86
87
3--51