Configurable Detent Operation - New Holland T6010 Operator's Manual

Configurable Detent Operation

(where fitted)
Your tractor may be fitted with two remote valves
having configurable detents. The rotary control (1),
is used to select one of five detent settings.
To select a setting, rotate the control until the number
(2), on the end cap, aligns with the mark (1), on the
valve body.
NOTE: If the number on the rotary control is not
aligned correcty with the reference mark on the valve
body, the performance of the valve may be affected.
Before turning the selector, ensure any residual
pressure in the hydraulic system is exhausted. To do
this, stop the tractor engine, cycle the remote valve
lever through all positions and then place the lever in
neutral.
Each position offers the follwing functions:
I. Raise (R), Neutral (N), Lower (L) and Float (F)
positions available.
Detent position in Float only.
No lever auto return to neutral (kick out).
II. Raise, Neutral and Lower positions only.
No Float facility.
No detent positions available.
No lever auto return to neutral (kick out).
III. Raise, Neutral, Lower and Float positions
available.
Detents in Raise, Lower and Float.
Lever auto return to neutral (kick out) in Raise
and Lower positions.
IV. Raise, Neutral, Lower and Float positions
available.
Detents in Raise, Lower and Float.
No lever auto return to neutral (kick out).
V. *
Raise and Float positions available.
Detents in Raise and Float.
No lever auto return to neutral (kick out).
3--62
SECTION 3 - - FIELD OPERATION
*
To select position 5, place the remote valve lever in
neutral, select position I or IV then move the lever to
the Float position. With the lever in Float select
position V.
To de--select position V, put the remote valve lever
into float, turn the selector control to position I or IV
and then move the remote valve lever to neutral. It
is now possible to select positions I to IV.
IMPORTANT: To prevent inadvertent movement of
attached equipment when starting the tractor engine,
ensure the remote valve levers are in the correct
position before operating the key- -start switch:
With the selector in positions I to IV -- Neutral
With the selector in position V -- Float
108