Change Air Brake Drier Reservoir; Removing The Drier Reservoir; Installing A New Drier Reservoir - New Holland T6010 Operator's Manual

OPERATION 33

CHANGE AIR BRAKE DRIER RESERVOIR

Removing the Drier Reservoir

Before attempting to change the drier reservoir (1),
thoroughly clean the area around the reservoir to
prevent debris from entering the air braking system.
1. Exhaust all air pressure in the system by opening
the drain tap on the main air tank/s.
2. Using a filter release tool, unscrew and remove
the drier reservoir. Dispose of properly according
to local regulations.

Installing a New Drier Reservoir

1. Clean the seal flange on the drier body and the
threaded pin, check for damage to the pin and
the seal contact surface of the flange.
2. Lightly grease the sealing ring on the reservoir
and the threaded pin on the drier body.
3. Screw the reservoir onto the drier body until the
seal touches the contact surface of the flange.
Tighten a further half--turn by hand. Tighten to a
maximum of 15 Nm (11 lbf. ft.) DO NOT
overtighten.
4. Pressurise the reservoir and check for leaks. If
further tightening is necessary, depressurise the
system before tightening.
5. Re--pressurise the air braking system and check
again for leaks.
SECTION 4 - - LUBRICATION AND MAINTENANCE
102
4--49