Three-Point Linkage Troubleshooting - New Holland T6010 Operator's Manual

PROBLEM
3- -point linkage does
not move when con-
trol lever is moved
External power lift
control does not op-
erate
3- -point linkage does
not raise fully
3- -point linkage
drops slowly
3- -point linkage slow
to respond to draft
loads
3- -point linkage too
responsive to draft
loads
3- -point linkage sta-
tus light flashes con-
tinually
SECTION 5 - - FAULT FINDING
THREE- -POINT LINKAGE
POSSIBLE CAUSE
Error code will indicate source of
malfunction.
Hitch not in phase with the control
lever.
Fast raise switch in external control
position.
Height limit control incorrectly
positioned.
Fast raise switch not in external
control position.
Height limit control incorrectly
positioned.
Drop rate control incorrectly
positioned.
Position/draft control incorrectly
adjusted.
Drop rate too slow.
Implement not functioning properly.
Position/draft control incorrectly
adjusted.
Position/draft control incorrectly
adjusted.
CORRECTION
See your authorised dealer.
Put lift control lever back in phase with
lower links.
Put switch in correct position.
Adjust height limit control.
Centralise switch (external control
position).
Adjust height limit control.
Adjust drop rate control.
Adjust position/draft control.
Adjust drop rate control.
See implement operator's manual.
Adjust position/draft control.
Adjust position/draft control.
5--9