Loader Subframe And Control Valve (Joystick); Joystick Operation - New Holland T6010 Operator's Manual

LOADER SUBFRAME and CONTROL
VALVE (JOYSTICK)
Operating
If your tractor is equipped with the optional front
loader, a mid mounted remote control valve with
two spools will have been fitted. The valves are
controlled by a joystick mounted on the right--hand
side of the seat. The joystick is able to operate two
services simultaneously by moving it diagonally.
The lever lock provides selective control of the
joystick. With the lock pushed fully in, position (1), the
joystick is fixed in neutral and the remote valves
cannot be operated, either by accident or by choice.
If the lock is pulled fully out, position (3), valves I and
II may be operated independently or together by
moving the joystick control in the appropriate
direction.
In the intermeadiate position (2), lateral movement of
the joystick that operates valve II is locked.

Joystick Operation

Pull the joystick rearwards (R) to raise the loader. If
required, pulling the joystick fully rearward against
spring pressure will provide a faster rate of lift.
Pushing the joystick forward to the 'lower' position (L)
will cause the loader to lower to the ground at a
controlled rate of descent.
Further forward movement of the joystick will select
'float' (F) which will allow the loader arms to move up
and down freely. When using the float position to
lower the loader, pushing the joystick fully forward
against spring pressure will cause the rate of drop to
slow.
Moving the joystick to the left (R) will cause the
bucket to roll upwards (crowd), moving the joystick
to the right (L) will roll the bucket out (dump).
IMPORTANT: Do not hold the lever in the raise or
lower positions once the loader or bucket cylinder
has reached the extent of its travel. This will cause
the relief valve to 'blow' which, if occuring over an
extended period, may overheat the oil.
SECTION 7 - - ACCESSORIES
6
7
7--5