Transmission -- 24 X 24 Dual Command - New Holland T6010 Operator's Manual

PROBLEM
Tractor does not
drive in any gear
Poor inching control
when using inching
pedal (clutch pedal)
Jerky gear shifting
Jumping out of gear
or holding in gear
High transmission
operating tempera-
ture
Low transmission oil
pressure
Noisy transmission
Gear engagement
difficult
Engine stalls when
changing from Hi
drive to Lo drive
Engine stalls when
changing from Lo
drive to Hi drive
5--6
SECTION 5 - - FAULT FINDING
TRANSMISSION - - DUAL COMMAND
POSSIBLE CAUSE
Error code will indicate source of
malfunction.
Transmission clutch fill time out
of adjustment.
Transmission clutches require
calibration.
Worn synchronisers/couplers.
Low oil level.
Incorrect oil grade/viscosity.
Dirty or blocked transmission
oil cooler.
Low oil level.
Incorrect oil grade/viscosity.
Blocked transmission oil filter.
Low oil level.
Incorrect oil grade/viscosity.
Worn bearings or failed parts.
Incorrect linkage adjustment or
worn linkage.
Worn shift forks/selectors.
Worn bearings.
Defective Hi drive clutch pack.
Defective Lo drive clutch pack.
CORRECTION
See your authorised dealer.
See your authorised
dealer.
Perform transmission clutch calibration
procedure or see your authorised dealer.
See your authorised dealer.
Add oil, as required.
Drain and refill with oil of the correct
specification.
Clean.
Add oil, as required.
Drain and refill with oil of the correct
specification.
Replace filter.
Add oil, as required.
Drain and refill with oil of the correct
specification.
See your authorised dealer.
Adjust linkage, replace worn parts or
see your authorised dealer.
See your authorised dealer.
See your authorised dealer.
See your authorised dealer.
See your authorised dealer.