New Holland T6010 Operator's Manual page 124

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION
Error Codes
In the unlikely event of a fault occurring in the
transmission controls or electronic circuitry, the
malfunction symbol (1) and a four-digit error code
(2), will appear in the Dot Matrix Display.
The code indicates the faulty circuit or sensor and the
type of fault, e.g., open circuit, short circuit, etc. In
this event, the tractor will require the attention of your
authorised dealer.
Should a fault occur causing the tractor to become
disabled, contact your authorised dealer and report
the error code displayed.
There are a number of 'action reqired' error codes
which can also appear in the Dot Matrix Display,
these are listed below.
Error
Code Fault
P Park brake on.
Place the shuttle lever in neutral.
N
CP Depress clutch pedal to enable
transmission (restore drive).
Transmission Calibration
Should transmission shifts become slow or jerky, the
clutches in the transmission
re--calibrating. Consult your authorised dealer.
2--96
may require
1
2
147