Gear Displays; Led Gear Display; Digital Gear Display; Clutch Pedal - New Holland T6010 Operator's Manual

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION

Gear Displays

Dependent upon tractor specification, two types of
gear display may be fitted.

LED Gear Display

An illuminated display (1), to the right of the main shift
lever indicates the gear selected.
As each gear is selected, the appropriate number (3)
will be illuminated in the display. With Auto Shift
engaged, the symbols for Active Road (2) and Active
Field (4) will also be illuminated. When changing the
Auto Shift point, symbol (5) will flash during the
programming procedure.
NOTE: Auto Shift is an option and may not be fitted
to your tractor.

Digital Gear Display

The digital display provides a comprehensive range
of information that includes:
Field and road Auto Shift (1) symbols.
Forward and reverse gears (2). The display
shows the current forward gear and the
corresponding reverse or 'shuttle' gear.
Shuttle lever position. Forward, neutral and
reverse (3).
Gear span for each range (4).

Clutch Pedal

It is not necessary to use the clutch pedal (1) to make
a powershift or when shuttle shifting (changing
direction between forward and reverse). Use of the
clutch is recommended for positioning the tractor
when attaching equipment or operating in confined
spaces when the low gears are not slow enough, at
moderate/low engine speeds, to give precise control.
IMPORTANT: To avoid premature clutch wear, do
not use the clutch pedal as a footrest.
NOTE: There may be occasions when error codes
'N' or 'CP' flash in the Dot Matrix and Digital Gear
Displays (where fitted). Should this occur, move
shuttle lever to neutral ('N') or cycle the clutch pedal
('CP') to clear the error.
2--88
131
132
133