Track Settings; Adjustable Rim (Types 1 And 2) - New Holland T6010 Operator's Manual

The sectioned drawings shown, illustrate the wheel
rim and disc positions relative to the hub at various

track settings.

IMPORTANT: When
right- -hand wheel assemblies, ensure the "V" of the
tread at the top of the tyre remains pointing in the
direction of forward travel.
When refitting or adjusting a wheel, tighten the bolts
to the following torques then re-check after 50 hours
of operation and thereafter as required.
Rear disc to hub nuts
Rear disc to rim nuts
M16 nuts
Track Settings

Adjustable Rim (Types 1 and 2)

Track
setting
Figure 224
A
B
C
D
E
F
G
H
NOTE: With the larger tyre sizes, the narrower track
settings may not be attainable due to minimal
clearance between tyres and fenders or equipment.
The dimensions shown in the above chart relating
to Figure 224 are nominal and should be used as
a guide only. Track settings may vary dependent
upon wheel type and tyre size.
SECTION 3 - - FIELD OPERATION
interchanging left
250 Nm (184 lbf. ft.)
250 Nm (184 lbf. ft.)
All Models
34" and 38" Wheels
Figures 221, 222
1412 mm (55.5 in.)
1510 mm (59.4 in.)
1614 mm (63.5 in.)
1710 mm (67.3 in.)
1812 mm (71.3 in.)
1910 mm (75.1 in.)
2014 mm (79.2 in.)
2110 mm (83.0 in.)
and
A
B
C
D
E
F
G
H
3--129
224