Turning the Printer OFF
Turn the printer OFF using the following procedure. The procedure for turning the
printer OFF is different between when a hard disk is used and when it is not used.
When using the hard disk, be sure to turn the printer OFF as the procedure for the
protection of the hard disk. (See p. 2-4)
If the printer is connected to a network, make sure that other computers are not sending
print data to the printer before turning the printer OFF.
If you turn the printer OFF when the Job indicator is on, all the print data remaining in the
printer memory will be erased. If there is any necessary print data remaining in the
printer, wait until it is output, or press [Reset] in the ofﬂine state and then select FORM
FEED to output the data before turning the printer OFF. (See p. 2-61)
Do not turn the power OFF when the printer is in any of the following status:
- During printing
- While the printer is running a self-diagnostic test immediately after turning the power
- While a message informing you that the NVRAM is being initialized or being written is
- While <02 STARTING UP> or <02 CALIBRATING> is displayed
When you are using a hard disk, make sure that the HDD indicator is not on. If you turn
the printer OFF while the HDD indicator is on (while data is being read from the hard disk
or being written to the hard disk), the hard disk may be damaged and disabled.
When Not Using a Hard Disk
When you are not using a hard disk, turn the printer OFF using the following
Turning the Printer ON/OFF
Make sure that the Job indicator is off.