Canon Laser Shot LBP5970 User Manual page 455

Remedy 2 If you are using the PS/UFR II printer driver and select the [Print with Upper Left
IMPORTANT
Depending on the print data to be printed, the edge of paper may be missing partly
during printing or may blot during color printing.
Toner does not fix well.
Cause 1
Remedy
Cause 2
Remedy
7
Cause 3
Remedy 1 If <Ennn-nnnn> is displayed in the display, turn the power OFF, wait for 10
Remedy 2 If the message does not disappear even after applying the Remedy 1, contact
The printed colors appear different from those printed by another LBP5970 being
used at the same time.
Cause 1
Remedy
7-60 When You Cannot Obtain Appropriate Printout Results
of Sheet as Starting Point] check box in the printer driver, you can extend the
printable area to near the edges of the paper.
In order to specify the setting for [Print with Upper Left of Sheet as Starting
Point], display the following dialog box.
- For UFR II Printer Driver: Display the [Finishing Details] dialog box by clicking
[Finishing Details] in the [Finishing] sheet.
- For PS Printer Driver: See Help of the PS printer driver.
Appropriate paper is not being used.
Replace the paper with one that can be used with this printer. (See "Paper
Requirements," on p. 3-2)
Toner may not fix onto paper completely depending on the paper type.
Set [Gray Compensation] to [On] in the printer driver.
In order to specify the setting for [Gray Compensation], display the following
dialog box.
- For UFR II Printer Driver: Display the [Advanced Settings] dialog box by
clicking [Details] in the [Quality] sheet, then clicking [Advanced Settings] in the
[Detailed Settings] dialog box.
- For PCL/PS Printer Driver: See Help of the PCL/PS printer driver.
A problem has occurred inside the printer.
seconds or longer, and then turn the power ON again. This may clear the
message.
your local authorized Canon dealer for servicing.
The default setting of the toner density of K (Black), Y (Yellow), M
(Magenta), or C (Cyan) is somewhat varied.
Adjust the toner density of the drum cartridge of K (Black), Y (Yellow), M
(Magenta), or C (Cyan). (See "Adjusting the Color Balance," on p. 7-95)