Canon Laser Shot LBP5970 User Manual page 450

Cause 2 MODE SELECTION in the PRINT MODE options in the SETUP menu is set
to AUTO SELECTION, and the set time for MODE TIMEOUT in the
INTERFACE MENU options in the SETUP menu is too short.
Remedy Set MODE SELECTION in the PRINT MODE options in the SETUP menu to a
setting value other than AUTO SELECTION or lengthen the set time for MODE
TIMEOUT enough. (See "MODE SELECTION," on p. 5-66)
Data is printed with its size reduced.
Cause The printer is set to reduce the print size.
Remedy Confirm the setting for [Manual Scaling] in the printer driver.
Paper comes out wrinkled.
Cause 1 Paper is loaded in the paper cassette or multi-purpose tray at an angle.
Remedy Load the paper in the paper cassette or multi-purpose tray straight. (See
"Loading Paper in Cassette 1," on p. 3-20, "Loading Paper (Other than
Envelopes)," on p. 3-49)
Cause 2 Paper is damp since the paper has been stored in unsuitable condition.
Remedy Replace the paper with new one and print again. (See "Paper Requirements,"
on p. 3-2)
Cause 3 The fixing unit is nearing the end of its life.
Remedy Perform Configuration Page Print, check the value of the counter of the fixing
unit. If the number of sheets has been increased by approximately 150,000
sheets since you replaced the fixing unit last time, replace the fixing unit with a
new one. (See "Replacing the Fixing Unit," on p. 6-43)
Paper curls.
Cause 1 Paper is damp since the paper has been stored in unsuitable condition.
Remedy Replace the paper with new one and print again. (See "Paper Requirements,"
on p. 3-2)
Cause 2 Paper is inappropriate.
Remedy Replace the paper with one that can be used with this printer. (See "Paper
Requirements," on p. 3-2)
Cause 3 The paper is too thin.
Remedy Set [Paper Type] to [Plain Paper L] in the printer driver.
In order to specify the setting for [Paper Type], display the [Paper Source] sheet.
When You Cannot Obtain Appropriate Printout Results
7
7-55