Printing Test Chart 1 - Canon Laser Shot LBP5970 User Manual

23
Utility
Press [Utility].
UTILITY MENU
CONFIG.PAGE
Utility 24
Select CALIBRATION using [
Settings
CALIBRATION
02 CALIBRATING
OK
Calibration is performed. The Ready indicator and Online indicator blink during
the calibration.
After completing the calibration, the message <00 READY> appears in the
display.
NOTE
Calibration takes approximately 50 seconds.
25
After performing calibration, print the print data in which print
defect appeared again.
If the print defect problem is solved, you can use the printer as normal. If the print
defect problem is not solved, go on to perform "Printing Test Chart 1" (See p.
7-87).

Printing Test Chart 1

Print Test Chart 1 when checking if the poor print quality is due to any problem in
the drum cartridges. Print Test Chart 1 using the following procedure.
NOTE
Test Chart 1 is printed on 8 sheets of A4 size paper. Load A4 size paper.
Online
1
Make sure that the printer is online.
If the printer is not online, press [Online].
→
] and [ ], then press [OK].
→
When Any Print Defect Appears
7
7-87