WHEEL BRAKE ASSEMBLIES
Figure 6-34 Front Spindle Assembly (Four-Wheel Brake Vehicles)
8. Remove hub and bearing assembly from spindle shaft. Remove four bolts (22), cone washers (21), lock
washers (20) and hex nuts (19) that mount the brake assembly to the spindle (Figure 6-32, Page 6-15).
9. Remove brake cluster assembly from spindle.
FRONT BRAKE CLUSTER INSTALLATION
1. Install in reverse order of removal. Use bolts (22), cone washers (21), lock washers (20) and hex nuts
(19) to mount brake assembly (Figure 6-32, Page 6-15).
2. Tighten bolts to 30 ft-lb (41 N·m). Adjust brakes as previously described in this section for the appropriate
vehicle. Use new bow-tie pins when reconnecting brake cables.
1
11
10
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Cluster Removal and Installation
TYPICAL
4 PLACES
2
3
4
9
8
7
6
5
6
Page 6-19