Snubber; Snubber Removal; Snubber Installation - Club Car Turf 1 Service Manual

9
REAR SUSPENSION
4. Turf 1 and Carryall 1 vehicles:
4.1. Install spring retainer (22) and shock mount bracket (16) onto locating bolt at bottom center of leaf-
spring (Figure 9-3, Page 9-4). See preceding CAUTION.
4.2. Position jounce bumper mount (20) with spacer (21) onto axle tube. Install U-bolt (11), flat washers
(13) (if present), and lock nuts (14). Tighten U-bolt to 25 ft-lb (34 N·m) (Figure 9-3, Page 9-4).
5. All Turf and Carryall vehicles except Turf 1 and Carryall 1: Install shock mount bracket (16) onto
locating bolt at bottom center of leaf-spring (Figure 9-4, Page 9-5). See following NOTE.
5.1. Install U-bolt (11) and lock nuts (14). Tighten U-bolt to 25 ft-lb (34 N·m) (Figure 9-4, Page 9-5).
6. Install shock absorber. See Shock Absorber Installation on page 9-2. See following NOTE.
NOTE: When installing shock absorbers, make sure rear shocks have identical part numbers.

SNUBBER

See General Warning, Section 1, Page 1-1.
NOTE: The snubber is installed on the gasoline vehicle only.

SNUBBER REMOVAL

1. Support the powertrain with a floor jack under the engine mounting plate so that the snubber is raised
slightly and does not rest on the vehicle frame.
2. Remove the two bolts (2) and two lock nuts (1) securing the snubber bracket to the engine mounting plate
(Figure 9-5, Page 9-6).
3. Slide snubber and bracket assembly toward battery to remove it from vehicle.

SNUBBER INSTALLATION

1. Install in the reverse order of removal.
2. Tighten snubber bracket mounting nuts (1) to 13 ft-lb (17.6 N·m) (Figure 9-5, Page 9-6).
Figure 9-5 Snubber Brackets
Page 9-6 2012 Turf/Carryall Vehicle Maintenance and Service Manual
SNUBBER MOUNTING
BRACKET
SNUBBER
2
1
Snubber