Club Car Turf 1 Service Manual page 66

6
WHEEL BRAKE ASSEMBLIES
Brake Shoe Installation (Self-Adjusting Brakes), Continued:
NOTE: The trailing shoe has 17T stamped into the tip of the shoe flange (Figure 6-12,
Page 6-6). The leading shoe is stamped 17L. When installing the shoes, the stamp-
ings on both shoes should be oriented to the top of the brake assembly. When install-
ing the shoes on the passenger side of the vehicle, the side of the trailing shoe flange
marked 17T should be facing out and be visible. On the driver side, the 17L on the
leading shoe should be facing out and be visible.
When installed on the backing plate, the leading shoe (stamped 17L) is always ori-
ented toward the rear of the vehicle.
Figure 6-12 Trailing Shoe
2. Install the shoe retainer clip (1). Compress clip while turning retainer pin (2) into position (Figure 6-13,
Page 6-6).
3. Attach the springs onto the trailing shoe already installed. Hold the leading shoe next to the trailing shoe,
correctly oriented, and attach the springs to it (Figure 6-14, Page 6-6).
Figure 6-13 Retainer Clip
Page 6-6 2012 Turf/Carryall Vehicle Maintenance and Service Manual
17T STAMPING
ON TRAILING
SHOE
1
2
SILVER SPRING
Brake Shoe Installation (Self-Adjusting Brakes)
BRONZE SPRING
SPRING COILS
Note that the silver
spring is mounted with
the coils to the side of the
adjustment lever spring (A).
Figure 6-14 Spring Orientation
A