Brake Cluster Adjustment - Club Car Turf 1 Service Manual

WHEEL BRAKE ASSEMBLIES

BRAKE CLUSTER ADJUSTMENT

1. Chock wheels.
1.1. To provide slack in the brake cables, loosen the equalizer retaining nuts (1 and 5) on the equalizer
rod (2) (Figure 6-27, Page 6-13).
2. Four-wheel brake vehicles only: Loosen the front brake equalizer rod (Figure 6-28, Page 6-13).
3. Remove the dust cover (4) on the left and right rear brake cluster assemblies (Figure 6-29, Page 6-13
and Figure 6-30, Page 6-13).
2
4
1
Figure 6-27 Rear Equalizer Adjustment
5
4
Figure 6-29 Front Brake Adjustment Bolt
4. Use a torque wrench and a 7-mm 8-point socket or Club Car brake adjustment tool (CC P/N 1013582)
to turn the brake adjustment bolt (5) on each brake clockwise until it is tightened to 15 ft-lb (20.3 N·m)
then back off 5 clicks. See following NOTE.
NOTE: If a wheel can still be turned by hand after step 4, inspect the brake clusters and clean
and/or replace all parts that do not work properly.
5. Four-wheel brake vehicles only: Repeat procedure at front brake clusters.
5
6
2012 Turf/Carryall Vehicle Maintenance and Service Manual
Brake Adjustment (Manually-Adjusted Brakes)
1 3
2
5
Figure 6-28 Front Equalizer Adjustment
5
4
Figure 6-30 Rear Brake Adjustment Bolt
6
6
Page 6-13